The WEH® TV17GOS Shut-off valve for oxygen is used to shut off the flow in oxygen systems. Due to its compact design, it is ideal for installation in technical gas plants. It can also be installed in existing systems without any problems.
Thanks to its streamlined design, the shut-off valve impresses with high flow values and its extremely low-noise operation.
The WEH® TV17GOS is available with manual or pneumatic actuation (initial position NC or NO).
B1 -> B2
Pneumatic (NC resp. NO) for automatic control (e.g. via SPS)
Nominal bore (DN)
Max. allowable operating pressure PS
420 bar (6,090 psi)
0 °C up to +60 °C
≤ 5 x 10-3 mbar x l/s
Pilot pressure port P1
G1/4" female thread
6 - 8 bar (90 - 120 psi)
Measuring Port MA2
M28x1.5 male thread
Number of cycles
Maximum 1 cycle per minute
Brass and Monel® 400
Inlet valve seal
Conformity / Tests / Approvals
Type approval for suitability against adiabatic compression available
High flow rate
Light weight (approx. 4.2 kg resp. approx. 8.3 kg incl. pneumatic actuator)
Bidirectional sealing possible
Low investment costs
Low flow noise
Reduction of the number of valves needed in plant construction
Shut-off valve for filling, mixing, evacuating and discharging pipe systems or vessels of all types filled with inert gases at a pressure of up to 420 bar.
The shut-off valve is not designed for media of fluid group 1 as defined in the Pressure Equipment Directive 2014/64/EU or use in ATEX-relevant zones. Corresponding requirements can be evaluated by us on request.